Connerton Co CEG SERIES User Manual download pdf

Fine Cooking Equipment For Over 70 Years

1. Preparation For Installation:

Z223.1

Installation must be made by a licensed plumber.

2. Clearances And Ventilation:

Safe and satisfactory operation of the griddle depends, to a great

extent, upon it’s proper installation. It should be installed in accordance with the National Fuel

Gas Code , these instructions, and applicable State and Local Codes.

A gas pressure regulator is supplied with your griddle. The regulator must be installed before

connecting griddle to gas supply line.

The griddle and it’s individual shutoff valve must be disconnected from the gas supply piping

system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.45

kPa).

The griddle must be isolated from the gas supply piping system by closing it’s individual manual

shutoff valve during any pressure testing of the gas supply piping system at test pressures

equal to or less than 1/2 psig (3.45 kPa).

This griddle is designed for installation in non-combustible locations

only with 4” clearance from sides and 6” clearance from back.

Please note: air vent can plug with grease, thereby shutting

gas supply off. Install regulator in a drip-free area.

Installation,

Operation &

Maintenance

Instructions

CEG SERIES THERMOSTATIC GRIDDLES

For Your Safety

Do NOT store or use gasoline or

other flammable vapors and

liquids in the vicinity of this, or

any other equipment.

Warning!

Improper installation, adjustment, alteration, service or

maintenance can cause property damage, injury or

death. Read the installation, operation and maintenance

instructions thoroughly before installing or servicing

this equipment.

To Purchaser

After installation of your griddle, immediately contact your local gas supplier to obtain

information in the event the user of your equipment smells gas. This information must be

posted in a prominent location.

To User

Upon receipt of this griddle, inspect it thoroughly for any damage which may have occurred

during shipment. If damage is observed, contact the delivery agency immediately.

RETAIN THIS MANUAL FOR FUTURE USE

The Connerton Company

1131 E. Wakeham Avenue, Santa Ana, CA 92705-4145

Telephone: (714) 547-9218 Fax: (714) 547-1969

www.connertoncompany.com

1 2 3 4

Summary of Contents

Page 1 - The Connerton Company

Fine Cooking Equipment For Over 70 Years1. Preparation For Installation:Z223.1Installation must be made by a licensed plumber.2. Clearances And Ventil

Page 2

Keep equipment area free and clear from combustibles.3. Gas Piping:Please note: air vent on regulator can plugwith grease, thereby shutting gas supply

Page 3

CEG THERMOSTATICALLY-CONTROLLED GRIDDLES1. 05-476-xx Griddle Plate2. 05-400-xx Body3. 05-426-xx Front Panel9. 05-350-00 Pilot w/tubing10. 00-225-00 Pi

Page 4 - LIMITED WARRANTY

TROUBLESHOOTING GUIDESmall/no burner flame Regulator failure Unplug regulator vent hole orreplace regulator.Thermostatic calibration Re-calibrate ther

Comments to this Manuals

No comments

Connerton Co CEG SERIES User Manual

Browse online or download User Manual for Cookers Connerton Co CEG SERIES. Connerton Co CEG SERIES User's Manual [no]

Summary of Contents

Comments to this Manuals

Related products and manuals for Cookers Connerton Co CEG SERIES